Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - Viper FANG 32T-EU Manuel D'utilisation

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
au-tonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and
disposal. Before performing any procedure on the machine, the operators and qualified technicians must read this manual
carefully. Contact Viper in case of doubts concerning the interpretation of the instructions and for any further information.

TARGET

This manual is intended for operators and technicians qualified to perform the machine maintenance.
The operators must not perform procedures reserved for qualified technicians. Viper will not be answerable for damages
coming from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The User Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can
cause damage to it.

DECLARATION OF CONFORMITY

The declaration of conformity, supplied with the machine, certifies the machine conformity with the law in force.
NOTE
Two copies of the original declaration of conformity are provided together with the machine documentation.
The CE-declaration is printed in the Quick Start Guide.

IDENTIFICATION DATA

The machine model and serial number are marked on the plate.
This information is useful when requiring machine spare parts. Use the following table to write down the machine
identification data.
MACHINE mode.............................................................................
MACHINE serial number................................................................

OTHER REFERENCE MANUALS

− Service Manual (can be consulted at Viper Service Centers)
− Spare Parts List (see www.vipercleaning.eu)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be performed out by qualified personnel or by Viper Service
Centers. Only original spare parts and accessories must be used. Contact Viper for service or to order spare parts and
accessories, specifying the machine model and serial number.

CHANGES AND IMPROVEMENTS

Viper constantly improves its products and reserves the right to make changes and improvements at its discretion without being
obliged to apply such benefits to the machines that were previously sold.
Any change and/or addition of accessories must be approved and performed by Viper.

PURPOSE AND INTENDED USE

All automatic cleaning machines are exclusively intended for the wet cleaning of water-resistant floor coverings in building
interiors.
8
USER MANUAL