Viper FANG 32T-EU Manuel D'utilisation page 21

hub. Once in the holes, rotate the driver toward the spring clip to lock driver into place.
MOUNTING THE SQUEEGEE

Pull back on the squeegee lift lever to raise the squeegee bracket up.

Loosen the two knobs on the squeegee and slide the squeegee into the slots at the rear of the squeegee bracket. (the
wheels on the squeegee point to the back)

Tighten the knobs securely.
FILLING THE SOLUTION TANK
The Fang 32T-EU can be filled in two different locations:
a. Front fill area for use with a hose or a bucket.
b. Rear fill area for use with a hose only.

Determine which fill area you would like to use to fill the machine with water.

Fill solution tank with up to 52 liters of water. (water temperature should not exceed 40° C). The clear tube in the back
left of the machine has gallon markers to help determine the water level in the solution tank.
NOTE
If you are filling the solution tank with a bucket, make sure the bucket is clean. This will prevent debris from
clogging the lines or solenoid.
WARNING!
Do not put any flammable materials into solution tank. This can cause an explosion or a fire. Only use
recommended cleaning chemicals. Contact your janitorial supply distributor for recommendations on proper
chemicals.
MACHINE START AND STOP
WA RNING!
Do not operate machine unless you have read and understand this manual.

Set control housing to a comfortable operating height by squeezing together the two thumb levers (16) directly
underneath the housing.

Lower squeegee assembly to the floor by releasing the lift lever (14) from its locked position.

Lower brush head assembly to the foor by turn brush pressure switch(7)to ON position.

Turn vacuun motor switch (1) to " ON" position.

Turn brush motor switch (2) to "ON" position.

Turn the solution switch (5) to "ON" position.
a. Solution will not begin to flow until the operating triggers are pulled.

The Fang 32T-EU is self-propelled. The speed can be controlled by a knob (9) located on the right side of the control
housing.

The Fang 32T-EU has reverse. In order to activate reverse,there is a toggle switch (20) located on the left side of the
control housing.

To begin scrubbing, pull on one or both of the red operating triggers (27). When these triggers are pulled, the brush will
begin to spin and the solution will begin to flow.FANG32T-EU:will propel itself.FANG32T-EU:Begin scrubbing by
moving the machine forward.
WARNING!
Do not keep the machine in the same position with the pad / brush spinning, or you could cause damage to the
floor.

Adjust amount of solution flow by turning the solution control knob (8). Turn to the right for more solution, or turn left
USER MANUAL
ENGLISH
19