While Operating Machine - Viper FANG 32T-EU Manuel D'utilisation

because the residual autonomy will last for a few minutes (depending on battery characteristics and work to be performed).
When the red warning light (3) turns on, the autonomy is over. After a few seconds, the brush/pad-holder is automatically
tuned off, while the vacuum system and the drive system stay on, to finish drying the floor and drive the machine to the
appointed recharging area.
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.

WHILE OPERATING MACHINE


Occasionally look through the clear recovery tank lid to see if there is any foam build-up. If excessive foam is found, add
defoamer to the recovery tank.
WARNING!
Foam must not enter the float shut-off screen, or damage can occur to the vacuum motor. Foam will not activate
the machines float shut-off device.

Occasionally view the clear tube at the back left of the machine to check the amount of cleaning solution that is left in the
machine.

Occasionally check the battery level meter (3). When meter is in the red, recharge the batteries.
WARNING!
When battery meter is in the red, do not continue to operate the machine. Battery damage may result.

If the squeegee assembly leaves streaks on the floor, raise the squeegee off the floor and wipe the blades down with a
damp cloth.
WARNING!
Do not use your fingers to wipe or remove debris from the blades, as injury may occur.

When the solution tank runs empty, turn off the brush switch, solution switch and raise the brush head. Keep the squeegee
down and continue to vacuum until all the dirty water is picked up. (see TANK DRAINING section to learn how to drain
recovery and solution tanks)
NOTE
The brush motor is circuit breaker protected to protect it from damage. If this breaker trips, it can't be reset
immediately.
You must first determine what caused the circuit breaker to trip, and allow the motor to cool down before you
can reset the circuit breaker.
TANK DRAINING

Turn the power off on the machine.

With the squeegee and brush head in their "up" position, transport machine to approved area for draining tank(s).
DRAINING THE RECOVERY (DIRTY) TANK
NOTE
Any time scrubbing is completed, or when refilling solution tank, the recovery tank should be drained and
cleaned.
WARNING!
If the recovery tank is not drained when the solution tank has been refilled, foam or water may enter the float
shut-off mechanism and cause damage to the vacuum motor.

Remove the drain hose from the holder, and place the drain hose over the floor drain. Twist off the drain hose plug to
begin the draining process. In order to completely empty the recovery tank, hinge opens the recovery tank and let it rest
on the support stand.
USER MANUAL
ENGLISH
21