PLAYTIVE 353093_2007 Notice D'utilisation page 11

Avoiding material damage!
• All inflatables are susceptible to cold.
• For this reason never unfold and inflate the
product at a temperature lower than 15°C!
• In the event that the air pressure increases in
the hot sun, it must be balanced accordingly
by letting out air.
• Make sure that the product, especially when
inflated, does not come into contact with
stones, gravel, or sharp objects and does not
rub or scrape against anything; this can cause
damage to the plastic foil.
• Use only the correct pump adapters to insert
into the safety valves. The valves might other-
wise become damaged.
• Do not over-inflate because you then risk tea-
ring open the welded seams. Close the valves
properly after inflating.
• Avoid contact with sharp, hot, pointed, and
dangerous objects.
Assembly
Assembly should always be underta-
ken by an adult. Follow the individual
assembly steps in the order indicated.
• Choose an even and clean surface with
enough room to unpack and unfold the castle.
• Check that all the individual parts are there
and in good order and condition.
• After assembling for the second time you
should check the bouncy castle for any dama-
ge, holes and tears and seal them.
Inflation
Warning!
• Always inflate the air chambers com-
pletely!
• Avoid inflating the air chambers too
much because there is the risk of
over-stretching the welded seams and
even tearing them open.
• To inflate the product use standard
commercial foot pumps or double-
stroke piston pumps with the appro-
priate pump adapters
• To inflate the product do not use a
compressor or compressed air bottles.
This can lead to damage to the pro-
duct.
• Make sure that the chambers are
evenly inflated.
• Inflate each air chamber until it feels
firm. When you press with your
thumb against the air chamber it
should still give a little.
• WARNING!
Avoid using sunscreen and skin
care products containing alcohol.
Sunscreen and skin care products con-
taining alcohol can cause the colour
coating of this PVC inflatable product
to peel. This can lead to stains on your
body, your clothing, and other objects
that are in contact.
Sequence
WARNING!
Follow the correct sequence when infla-
ting the air chambers. Always inflate all
air chambers fully.
1. Floor chamber (1)
2. Side arches (2)
3. Side walls (3)
4. Longitudinal struts (4)
5. Basketball basket and target board (5)
Inflation
1. Open the valve on the bottom of the floor
compartment.
2. Fill the floor chamber (1) with air and close
the cap (fig. C). Inflate the air chamber until
it feels firm. When you press with your thumb
against the air chamber it should still give a
little.
Close the valve seal and push in the valve by
pressing gently.
3. To fill components 2-5 open the valve seal
and inflate the air chambers (fig. B). Close the
valve seal and push in the valve by pressing
gently.
Tethering the bouncy castle
Fasten the product securely at the eight fastening
loops (1a) using one peg (8) each on an even
grass surface (fig. A).
GB/IE 11