Meister SB500M Traduction Du Manuel D'utilisation Original page 41

5402020-Schlagbohr_man1 24.04.18 07:03 Seite 41
The additional handle can be attached
both righthand or lefthand of the chuck.
Fitting and setting the depth stop
To obtain evenly identical drilling depths.
Undo the thumb screw (12) by turning it
counterclockwise. Place the depth
stop (8) into the guide (11) such that
either the numbers or the millimeter
scale is visible. Draw the depth stop out
as far as the tip of the drill placed in the
chuck – to do so place the drill on an
even surface.
Read the figure shown on the guide (11)
and subtract the desired drilling depth
from this figure. The new value is set by
sliding the depth stop along the guide.
Fix the depth stop by turning the thumb
screw (12) clockwise.
Inserting/removing bits
CAUTION! Always unplug before
changing bits.
Open the drill chuck (9) by rotating the
toothed ring to the left until the tool can
be inserted. In the event that tools are
stuck, use the drill chuck key.
Tension the drill chuck (9) at all drilled
holes evenly using the drill chuck key (13).
Selecting speed
WARNING! Pull out power plug.
The speed selector allows you to
adjust the number of revolutions
of the tool to the type of material
being drilled.
• Turn the speed selector on the On-Off
switch (4) in the (–) direction. The
maximum number of r.p.m. is
reduced.
• Turn the speed selector in the (+)
direction: The number of r.p.m. is
increased up to the maximum speed.
With the On-Off switch the number of
r.p.m. can be varied continuously within
the selected maximum speed.
Right or left (clockwise or anti-
clockwise) rotation
Setting according to the figure,
with the machine at standstill
(Fig. 4).
IMPORTANT! During operation
of the power tool, the clockwise/
anti-clockwise direction switch may
not be pressed (7), therefore await a
complete standstill.
Use clockwise rotation to drill holes.
41