Sinmag Europe PRIMO Mode D'emploi page 8

ENG
NOTE: Place some kind of protection on the front frame blades to avoid any
injury.
7.
Re-assemble the frame to the machine body.
8
3. Remove the front stainless steel table.
4.
At the top of the front frame, loosen the screws fastening the
frame to the machine body, and then turn down the front frame.
5.
Replace the blades of the front frame.
1. Loosen the FIRST LEFT 4 hexagonal socket head
screws which tighten the blades.
2. Replace the blades and check that they are well positio-
ned in the rocker arm pin.
3. Re-tension the blades by tightening screw, in order that
the blades remain in the frame as a mark of tension.
4. Then loosen the FIRST RIGHT 4 hexagonal socket
head screws which tighten the blades.
5. Resume at step 2 and work your way to the center by
alternating left and right side.
6.
Resume the above steps for the rear frame.
SINMAG EUROPE BVBA