AFG 18.1AXT Manuel Du Propriétaire page 19

ASSEMBLY STEp 10
BASE RAIL
LOWER
HANDLEBAR
JOINT COVERS
SCREWS (O)
LINK ARM
CENTER LEVELER
REAR LEVELERS
HARdWARE fOR STEp 10:
SCREW (O)
12 mm
Qty: 6
Open hardware for step 10.
A
Attach Joint Covers to the joint between
B
the link arm and the lower handlebar
using 3 sCrews (o).
Repeat on opposite side.
C
Adjust the 2 rear levelers so that the
D
machine is level on the floor. Then adjust the
Center leveler located under the base
rail just so it is snug with the floor.
ASSEMBLY COMPLETE!
19