Set Up Contact Between Remote Control And Motor; Night Light Function; Tuning The Hand-Held Transmitter To The Receiver - Hülsta PREMIUM Mode D'emploi

Please note! Before fi rst use under load, both base frames must be
moved to the maximum adjustment and back to the fl at position. moved to the maximum adjustment and back to the fl at position. moved to the maximum adjustment and back to the fl at position.
3.7 Remote control
1
Fig. 5
The remote control consists of remote hand-held transmitter and
remote app receiver with night light function.
Fig. 6
The operation of the remote hand-held transmitter corresponds to that
of the cable hand switch - see point 3.5
3.7 Installation remote control
remote – hand switch
Please remove the contact protection of the batteries in the battery
compartment of the remote hand-held transmitter (Fig. 6).
Fig. 8
30
PLEASE NOTE
The remote control is not covered by the TÜV-GS
certifi cation! Functions that are not within the user's
visual control can be triggered via the remote control
– therefore GS certifi cation can generally not be
granted here.
3.7.1 Set up contact between remote control and motor unit
The receiver does not require a battery.
Insert 6-pin receiver plug into motor, insert cable protection.
Control is now carried out by the remote hand-held transmitter.
After a power cut, unplugging the mains plug or changing the batteries
of the hand-held transmitter, it is not necessary to re-establish the
contact between the remote control and the motor unit. The stored
connection is retained.

3.7.2 Night light function

The receiver of the remote control is equipped with an LED light that
can be switched on and off by pressing the buttons 5+6 together. With
a little skill, you can press both buttons with your thumb.
As an orientation light, the receiver can be positioned within reach of the
cable.

3.7.3 Tuning the hand-held transmitter to the receiver:

When delivered, the transmitter is already tuned to the receiver. However,
if tuning between the transmitter and receiver should become necessary,
please proceed as follows:
Pull out the receiver connector plug to the motor.
Press and hold the button on the receiver, reconnect the connecting
cable to the motor. Then press any button on the transmitter, you can
now adjust your hülsta base frame using the remote hand-held
transmitter.
Fig. 9
31