Güde WX 125 Traduction Du Mode D'emploi D'origine page 11

• Lay the cables in a way to avoid cable damage.
•
Provide adequate ventilation.
•
Make sure that bystanders keep sufficient safety
distance!
• Keep all items that could get damaged as a result of high
temperatures out of reach of the appliance when it is
being operated.
• Do not use the appliance in an environment with
flammable gases, e.g. bilges of boats powered by
gasoline or near propane tanks.
• Switch the appliance off after being operated.
•
The engine must be cooled well when being operated,
which is why the ventilation slots must always be clean.
• (WX 125 #58000 angular grinders only) The closed
protection cover must be fitted for dividing. The open
cover may be used for rough machining.
Assembly (pic. III)
1 Protection cover (WX 125 #58000 angular grinders
only) The closed protection cover must be fitted for
dividing. The open cover may be used for rough
machining.
2 Clamping flange
3 Grinding wheel
4 Flange nut
The appliance is ready to be operated after being assembled.
Electrical connection
The angle grinder has been designed for 230 V~50 Hz AC.
To be plugged to outlets with grounding only!
Working voltage: Make sure the working voltage
specified on the type label matches the voltage of your
power supply.
Grinding wheels
Never use a wheel that is bigger than the allowed wheel
diameter. The allowed wheel revolutions must always be
checked before any assembly and use. Revolutions printed
on the wheel must necessarily be higher than the idle speed
of the angle grinder.
Let the grinder run idle for app. 1 minute before
starting your work. Any unbalanced wheel must be
immediately replaced!
Fitting the flange at grinding or dividing wheels
Centering flange
Flange fitting at a grinding wheel with embedded or straight
centre. (pic. V)
Clamping flange
Flange fitting at a dividing wheel with a straight centering
flange. (pic. VI)
Flange fitting at a dividing wheel with an embedded centering
flange. (rotate the flange) (pic. VII)
Work proposal/Roughing grinding
Keep the wheel at 30° - 40° against the workpiece surface
and grind with regular motions.
Dividing grinding
Do not rotate the angle grinder at the edge level when
dividing. The dividing wheel must have a clean cutting edge.
To divide hard stones, a diamond dividing wheel is the best
option.
Caution! Asbestos materials must not be machines!
Caution! Never use dividing wheels for roughing
grinding!
Carbon brushes
Have the carbon brushes checked by an electrician when
sparks are produced excessively. Caution! Carbon brushes
may only be replaced by an electrician.
Residual risks and protective measures
Electrical residual risks:
Risk Description
Direct Electric shock
electric
contact:
Indirect Electric shock
electric through a medium
contact:
Other risks:
Risk Description
Thrown-away Divided items may
items and be thrown away by
spraying the grinder and
liquids cause serious
injuries.
Slipping, The electric cable
tripping or and appliance itself
falling of may be a reason of
persons tripping.
Marking:
Product safety:
Product corresponds to
applicable EU standards and
directives
Prohibitions:
General prohibition sign
Do not work with jewels in any
case!
Do not use the appliance when
raining!
Do not pull the plug or carry
the appliance by the plug!
11
Protective measure(s)
RCD
RCD
Protective measure(s)
Gloves and protective
glasses to be worn at all
times.
Take appropriate
measures, depending on
the type of installation
(appropriate place,
installation, installation
place marking, etc.).
Do not work with long hair
not being covered with a
hairnet!
Do not work with a tie or
loose, hanging pieces of
clothing!
Do not touch in the
appliance when working!