Repair Service; Technical Specifications - Grizzly ARM 2432 Lion Set Traduction De La Notice D'utilisation Originale

Repair Service

• Repairs, which are not covered by
the guarantee, can be carried out for
charge by our service center. Our ser-
vice center will be glad to provide you
with a cost estimate.
We can only process devices which
have been packaged sufficiently and
which have been dispatched with cor-
rect stamping.
• Note: In case of complaint or service,
please deliver your device cleaned,
and with an indication of the defect, to
our service address.
Devices sent in freight collect - by bulk
freight, express or with other special
freight - are not accepted.
• Defective units returned to us will be
disposed of for free.

Technical Specifications

Cordless
lawnmower .............. ARM 2432 Lion Set
Motor voltage ......................24 V
Idling speed ............................ 3400 min-1
Cutting circle ............................... 320 mm
Cut height .......... 25 / 35 / 45 / 55 / 65 mm
Protection class .................................... III
Protection type...................................IPX1
Weight
(without battery and recharger) .......9.7 kg
Lawn bag volume ................................30 l
Sound pressure specification
(L ) ..........................77 dB(A); K
pA
Noise level specification (L
measured......... 88.25 dB(A); K
guaranteed ................................. 90 dB(A)
Vibration (a ) ........ 2.391 m/s
h
Battery (Li-Ion) ........................24LB4005
Nominal voltage ............................ 24 V
Capacity.......................................... 4,0 Ah
4,0 Ah
= 3 dB
pA
)
WA
= 1.5 dB
WA
; K= 1.5 m/s
2 2
Energy ......................................... 86.0 Wh
Charging time ...................... approx. 7-9 h
Recharger ..............HYCHO 132400500G
Voltage
input ........... 100-240 V~, 50-60 Hz, 0.32 A
Voltage output..................24 V
Protection class ................................
Protection category............................ IP20
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value may differ
during actual use of the power tool from
the stated value depending on the manner
in which the power tool is used.
Safety precautions aimed at protecting
the user should be based on estimated
exposure under actual usage conditions
(all parts of the operating cycle are to be
considered, including, for example, times
during which the power tool is turned off
and times when the tool is turned on but is
running idle).
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-
ment without notice. All dimensions, refe-
rences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid
GB
500 mA
II
35