Interruption/End Of Training; Resumption Of Training - Kettler SM3600 Mode D'emploi Et Instructions D'entraînement

Training and Operating Instructions
Pulse value at REC start
Pulse value after REC end
Difference (REC start-REC
end)
Fitness mark
11
GB
Adjustment of the strain profile
If the strain is adjusted during the programme flow, the
change appears from the flashing column to the right. The
columns left of it show the realised strain levels and
remain unchanged.

Interruption/end of training

The electronics detects an interruption of the training in
case of less than 10 pedal revolutions/min or pressing
"RECOVERY". The achieved training data is shown. Pulse,
strain, revolutions and speed are shown as average valu-
es with Ø symbol.
Change to the current display by means of "Plus" or
"Minus".
The training data is shown for 4 minutes.
If you do not press any buttons during this period and do
not exercise, the electronics switches over to standby
mode.

Resumption of training

If the training is continued within 4 minutes, the last values
will also be counted or counted down.
RECOVERY function
Measuring the recovery pulse
The electronics reversingly measures your pulse for 60
seconds and determines a fitness mark.
Press "RECOVERY" at the end of the training. The current
pulse value (in the figure "168") is stored. After 60
seconds the pulse value (in the figure "137") is stored
again. The difference between both values (in the figure
"31") is shown, based on which a fitness mark (in the
figure "F 2.6") is determined. The display ends after 10
seconds.
"RECOVERY" or "RESET" interrupts the function.
If no pulse is measured at the beginning or end of the
time return, an error message will appear.