Troubleshooting; Technical Data; Compressor - Pari COMPACT2 Mode D'emploi

5

TROUBLESHOOTING

The compressor must not be repaired except by the Technical
Service of PARI GmbH or a service center expressly
authorised to do so by PARI GmbH. If the compressor is
opened or manipulated by anyone else, all claims under the
warranty shall be void. In these cases, PARI GmbH will accept
no liability.
Fault
The

compressor

does not start
up.
No aerosol is
coming out of
the nebuliser.
6

TECHNICAL DATA

6.1 Compressor
General compressor data
Supply voltage [V]
Mains frequency [Hz]
Power consumption [A]
– 33 –
Possible cause
The power plug is
not plugged into the
mains socket
properly.
The supply voltage is
not suitable for
running the
compressor.
The nebuliser nozzle
insert is blocked.
The connection
tubing is not
connected properly.
The connection
tubing is leaking.
Remedy
Check whether the power
plug is plugged into the
socket correctly.
Check whether the local
supply voltage matches the
voltage data marked on the
compressor identification
label.
Clean the nebuliser.
Check that the tubing
connectors are connected
firmly to the compressor and
the nebuliser.
Replace the connection
tubing.
see label on confirmation of
purchase