SentrySafe Fire-Safe Série Manuel Du Propriétaire page 6

4
5
NOTE: • Make sure the handle is rotated all the way up in the horizontal position before
unlocking the safe.
• If the door does not open easily, repeat steps 1-5.
• If you exert too much force on the handle, the handle will move without moving the
bolts. If this happens, you will hear a 'click.' DO NOT be alarmed. This feature is
designed to protect the bolts from being overpowered by force. If this occurs, simply
exert force in the opposite direction (lifting up) until the handles 'clicks' back into place
and repeat steps 1-5 to open your safe.
Locking your safe
1
2
3
Rotate the dial to the right (clockwise), stop when you reach
the third number in your combination.
Rotate the handle downward to open the door.
This may take a limited amount of force if you have a
water-resistant safe.
Close the door and pull the handle upward until the handle
is horizontal.
For water-resistant units, additional pressure to the front,
left side of the door may need to be applied prior to rotating
the handle.
Spin the dial at least 2x to the right (clockwise).
FOR DUAL KEY/COMBINATION LOCKS ONLY, insert key
into the lock, turn to the 'locked' position, then remove the key.
5