SentrySafe Fire-Safe Série Manuel Du Propriétaire page 9

Programming information
NOTE: • The "C" key is a clear key. This can be used at anytime to clear the system and return to
standby mode – unless you are in delay mode (3 consecutive invalid entries).
• The 5 digit factory code cannot be deleted. However, you may add and delete
additional codes.
This safe can store up to three codes at one time. One factory code and two
additional programmable codes.
Programming the user code
To ADD a user code:
Press the "P" key.
1
Enter the 5 digit factory code found on the back of your owner's manual.
2
The light will flash green and then you will have five seconds to enter your own
3
personal 5 digit user code.
To DELETE a user code:
Press the "P" key.
1
Enter the 5 digit factory code.
2
Enter 0,0,0,0,0.
3
NOTE: • The electronic lock will NOT indicate that it has deleted the user code – please test the
code to make sure it has been deleted.
Programming the secondary code
To ADD a secondary code:
Press the "P" key two times.
1
Enter the 5 digit user code previously programmed.
2
Programmable Electronic Lock
Three code options:
Factory code:
The safe will ALWAYS unlock using this 5 digit code (found on the
back of the owner's manual). This code cannot be deleted.
User code:
A 5 digit programmable code of your choosing that can be changed
or deleted.
Secondary code:
A second 5 digit programmable code of your choosing that can be
changed or deleted. Can only be programmed after a user code
has been activated.
8