KLS Martin group Angulus2 Mode D'emploi page 44

Test run
Danger of injury due to wrong handling!
Do not hold the angled screwdriver at eye level.
•
Attach the angled screwdriver to the motor.
•
• Insert the tool.
Start the motor.
•
NOTICE
If you observe problems (e.g. vibrations, unusual noise, overheating), stop the angled
•
screwdriver immediately.
— Contact an authorized service partner from Gebrüder Martin!
Removing the tool
To remove the tool, push the tension clip (1) forwards.
•
Remove the tool
•
44
or remove the tool by pressing with a pair of tweezers.
Instructions for Use
Angulus2 Angled Screwdriver
Revision 04