Güde PRO 460 BS Mode D'emploi Original page 13

Do not change the basic engine adjustment and make
sure it is not overloaded.
Be especially careful when turning the mower or pulling it
towards your body.
Switch off the knife if the mower needs to be inclined or
lifted to pass a surface other than grass or when carrying
the mower to or from the area to be cut.
Release all knives and drive clutches before starting the
engine.
Start the engine in accordance with the Operating
Instructions and make sure your legs are in safe distance
from the knife.
Do not incline the mower when starting except when it is
necessary. Do not incline the mower more than
necessary in such a case and always lift the part
reversed from you.
Do not start the engine when standing in front of the
ejection outlet.
Never lift and carry the mower with the engine running.
Reduce the brake adjustment when the engine is off. If
the engine is fitted with a stop valve then close the petrol
supply after cutting.
Make sure your posture is always safe on slopes.
Do not let the combustion engine run in closed spaces
where carbon monoxide can be accumulated.
Assembly/preparation
CAUTION: All the assembly and servicing works must
necessarily be performed when the engine is off!
Please read the entire Operating Instructions before
assembling or starting your new mower.
IMPORTANT: The mower is supplied with no oil and
petrol.
Unpacking the mower
Take the mower out of the board and check whether there
are any free parts left.
Grass catcher assembly
Take the grass catcher out of the package and fit it to the
appropriate frame according to the picture.
Assembly - handle
IMPORTANT: Disassemble the handle with care to prevent
squeezing or damage of the cables.
Lift the handle until it snaps in the working
position.
Remove the protection package, lift the upper parts of the
handle and assemble it with the bottom part.
Tighten the safety bolts on both sides of the handle.
Remove the protection sleeve of the operation grab handle in
the upper part.
Operation
Operating lever (for automatic stopping) (12) – press
the lever towards the handle when starting. Release the
lever to switch the engine off.
Drive lever (13) - used when you want the mower to be
moving forward.
Loslassen – release
Nach oben drücken – press up
Area of use
13