Güde PRO 460 BS Mode D'emploi Original page 15

Stopping the engine
If you want to stop the engine, release the operating lever
(automatic switch-off lever) (12).
WARNING! The knife still rotates for a few seconds after the
engine is switched off. If you want to leave the mower laying
unattended then disconnect the spark plug cap.
Important tips and advice for grass cutting!!!
Under certain conditions, e.g. when the grass is very high, it
may be necessary to set a bigger cutting height so that effort
for pushing the mower is reduced, engine overloading
removed and blocking of grass in the mower prevented. It is
possible that you will also have to reduce the mower travel
speed and/or cut the area again.
Vent ports in the grass catcher may get blocked if the catcher
is not cleaned regularly. Clean the grass catcher regularly with
water and let it dry before use.
Keep the upper part of the engine at the starter clean. Air flow
will be improved.
Cut in dry weather only.
Keep the knives sharp at all times.
Maintenance
Original spare parts are supplied by the customer service
centre and dealers. An authorised service centre is
recommended to be entitled to provide yearly maintenance
and check of safety elements. For maintenance and spare
parts, please contact your dealer.
IMPORTANT – Regular maintenance is necessary for
constant operational reliability and keeping the original
appliance output at the same level. Keep all screws and nuts
tightened so that you are sure the appliance is in an operation-
reliable condition. Regular maintenance is necessary for safety
and trouble-free operation.
Never store the appliance with fuel in closed rooms as the
evaporating fuel may ignite.
It is necessary to let the appliance cool down and empty the
fuel before storing in closed rooms.
To minimise the risk of fire, keep the engine and muffler
and the fuel tank clean and with no grass, leaves and fats.
Do not store the grass cut with the mower.
For safety reasons, avoid using an appliance with a worn
or damaged parts. Replace any faulty parts with new ones,
do not repair them. Use original spare parts and original
spare knives only.
Parts with quality different from the specified quality may
damage the appliance and put you at risk.
If it is necessary to empty the fuel tank, do so outside with the
engine being cold.
Wear solid protective gloves when assembling and adjusting
the knives.
Check the correct direction of rotating and balance of knives
after they are sharpened.
Check regularly the wear and pollution of the self-closing cover
and grass catcher.
When transporting the appliance is necessary, carry it in
hands or incline it and wear safety gloves at all times.
At all times, hold the appliance where safe holding may be
guaranteed. Consider the weight and distribution of the
appliance.
Cleaning
Clean the appliance with water, remove the grass and mud from
inside every time the appliance is to be used – it will prevent dirt
from becoming dry and problems when started the next time.
Painting inside the housing may wear down in course of time.
To prevent later corrosion of the appliance, use anti-corrosive
paint for the worn-down spots.
Once or twice a year, remove the gearbox cover and clean the
space around belt pulleys and drive belts with a brush or
compressed air.
Once per season, you should clean the inside of the drive
wheels. Disassemble both wheels. Clean the cog wheels and
their edges off the grass and other dirt with compressed air or a
brush.
Knife disassembly
For purposes of cleaning/sharpening/change
Caution!!! It is necessary to disconnect the spark plug before
disassembling.
Release the screw when disassembling the knives.
Re-assemble according to the picture. Tighten the screws. Torsion
moment of 40 Nm. You should also replace the screw when
replacing the knives.
15