Setting The Cutting Depth; Vacuum Extraction Of Dust / Debris; Parking Shoe; The Planing Process - Parkside PEH 30 A1 Instructions D'utilisation Et Consignes De Sécurité

Preparing for use
Switching off:
R elease the ON / OFF switch
Note: For safety reasons the ON / OFF switch
cannot be locked in the ON position.

Setting the cutting depth

Q
The rotary control can be used to set the cutting
13
depth in steps from 0–3.0 mm according to the cut-
ting depth scale .
14
Vacuum extraction of dust /
Q
debris (see Fig. A)
Wear a dust mask!
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
Planing debris removal port (right / left
selectable):
R elease the planing debris removal port
turning it against the direction of the arrow (out
of the "Lock" position).
P ull the planing debris removal port
the device.
T he planing debris removal port
to face left or right in the planer.
P ush the planing debris removal port
the device.
L ock the planing debris removal port
turning it into the "Lock" position.
External vacuum extraction:
If necessary fit the vacuum cleaner adapter
using a dust extraction system, e.g. a workshop dust
extraction system.
The vacuum cleaner / dust extraction device used
must be suitable for the material being planed.
Connection:
P lace the vacuum cleaner adapter
to the planing debris removal port
20 GB/IE
.
2
2
Removal:
Q
The parking shoe
down without the risk of damaging the workpiece.
When planing, the parking shoe
exposes the rear part of the sole
Q
by
3
out of
3
can be set
3
into
3
by
3
Q
when
15
The V-grooves
to be used for simple chamfering of workpiece edges.
firmly on
15
.
3
P ush the hose of a suitable dust extraction device
approved for that purpose (e.g. a workshop
vacuum cleaner) on to the planing debris remov-
al port or the vacuum cleaner adapter
3
P ull the hose of the dust extraction device off
the planing debris removal port
vacuum cleaner adapter
P ull off the vacuum cleaner adapter
Parking shoe (see Figs. B / C)
allows you to lay the device
16

The planing process

C AUTION! DANGER OF KICKBACK!
Always switch on the device before placing it
against the workpiece.
S et the required cutting depth.
S witch on the device.
A lways place the front part of the sole
first on to the workpiece.
G uide the device with even forward movement
over the surface being planed.
M ove the device forward at a slow rate and
ensure that the contact pressure acts evenly on
the sole . Moving forward at too great a rate
9
results in a poorer surface quality and can lead
to blocking of the planing debris removal port.
Chamfering edges (see Fig. H)
in the front sole
10
U se the V-groove most appropriate to your
desired chamfer width.
P lace the planer with the V-groove
piece edge and guide the planer along the edge.
.
15
or off the
3
.
15
, if fitted.
15
swings up and
16
.
9
down
9
allow the device
9
on the work-
10