Sanding close to the edge
If you are sanding close to the edge, you can
remove a hood segment
suction hood
. This means that the accessory tool
you are using is closer to floor, wall and ceiling
edges as well as existing installations such as
pipes, and the adjacent surfaces can be precisely
machined.
Expect dust to develop during this work, as the
protective and suction hood
off.
♦
Pull the hood segment
protective and suction hood
♦
Work the surfaces close to the edge.
♦
Push the hood segment
hood
until it locks into place.
PWBS 180 B3
of the protective and
is no longer closed
forwards out of the
.
back into the suction
Operation
■
Tool direction of rotation!
Switching on
♦
To switch on the appliance, slide the On/Off
switch
forwards.
To lock the On/Off switch
switch
down at the front until it clicks
into place.
Switching off
♦
To switch off the power tool, let go of the On/
Off switch
. If it is locked, press the rear end
of the On/Off switch
Setting the rotational speed
Before starting work, set the speed to suit the appli-
cation. Use a low speed for coarse sanding;
increase the speed for fine sanding.
■
Adjust the speed by pressing the buttons
♦
Press the + button
♦
Press the – button
NOTE
►
The accessory tool rotates after switching off.
Wait until the accessory tool has come to a
standstill before putting down the appliance.
, press the On/Off
and then release it.
.
to increase the speed.
to decrease the speed.
GB │ IE
│
11
■