Descriptions Of The Control Panels; General Remarks; Controls On The Power Source - Fronius VarioSynergic 3400 Instructions De Service

Descriptions of the control panels

General remarks

Controls on the
power source
Fig.3
(1)
Warning! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described here until you have read and
completely understood all of the following documents:
- these Operating Instructions
- all operating instructions for the system components, especially the "Safety
rules"
(1)
(8)
(13)
(12)

Controls on the power source

Digital display V - inductance
function differs depending on whether it is in the manual or program mode
Manual mode
- Displays command, actual or „hold" value of the welding voltage set using
coarse and fine stage switch
Program mode
- Displays command, actual or „hold" value of the welding voltage set using
coarse and fine stage switch
- Welding current socket display 1/2/3 ... if the coarse or fine stage switch is
adjusted, the digital display shows the digit 1, 2, or 3. The grounding
(earthing) cable must be plugged into the relevant welding current socket 1,2
or 3 and fastened.
(2) (3)
4
(4)
(5)
(6)
(7)
(9)
(10)
(11)