Manual Welding - Fronius VarioSynergic 3400 Instructions De Service

MIG/MAG wel- 8.
ding
(continued)
Important! The sheet thickness, welding current and wirefeed speed parameters are
directly interlinked. It is only necessary to alter one of these parameters, and the other
parameters are automatically adjusted to match.
9.
10. Establish a connection to the workpiece with the other end of the earthing cable
11. Press the torch trigger and start welding

Manual welding

The MIG/MAG manual welding process is a process with no synergic function. The
correct operating point must be set by synchronising welding voltage (stage switch) and
wirefeed speed (wirefeed speed adjuster).
Specify the desired welding power with reference to any of the following parameters:
- Sheet thickness
- Welding current
- Wirefeed speed
(Anzeige über Wahlschalter Digitalanzeige einstellbar)
Plug earthing cable into welding current socket 1, 2 or 3 according to digital display
V - inductance, and fasten.
31