Adjusting The Collar To The Spray Device; Filling The Device - Petsafe Anti-Bark Spray Collar Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10

Adjusting the collar to the spray device

1. Remove the keeper from the black collar (A). Pass the black collar (B) through the loops
of the spray device (C). Put the keeper back on the collar (D). The curved edge of the
keeper should face inward.
A
2. Feed the free end of the collar into the slot of the buckle that is closest to the PetSafe
logo, from the back to the front (E). Then, thread the free end of the collar through the
outside slot, from the front to the back (F). The free end should now hang on the outside,
then thread the keeper (G). When you have completed this section, the assembled collar
looks as shown (H).
E
Take off all other collars your dog may be wearing and place the spray collar
around his neck, making sure the spray valve is directed toward the snout. Adjust
the collar to fi t like a regular collar. You should be able to easily pass two fi ngers
between your dog's neck and the device (I). We suggest that you check the collar
regularly to make sure that it is well adjusted.
Note: If these instructions are not properly followed, the buckle can easily be
pulled off the collar. This could lead to the device being lost or damaged.
Your dog must get used to the device before you actually start using it. We suggest that you
make your dog wear the Anti-Bark Spray Collar
fi lling the device. At the same time, we also suggest that you remove and put the collar back
on your dog frequently.

Filling the device

The Anti-Bark Spray Collar
help you see when your reservoir is getting empty (J).
1. Set the device on a fl at surface with the fi ll-up valve (the deepest cavity) turned upwards
(K). Shake the spray can before using it.
2. Hold the can upside down, then insert the aerosol tip in the fi ll-up valve (L) – press down
fi rmly for 10 seconds (M). Release pressure and press down for another 10 seconds,
then release.
Note: If spray is escaping as you attempt to fi ll the device, increase the downward pressure on the refi ll can
to get a better seal. When completely fi lled, there should be enough gas in your device for 18-23 sprays.
J
B
F
Deluxe has a see-through reservoir with a level indicator to
K
www.petsafe.net
C
G
4 to 5 days before inserting the battery and
L
D
®
H
I
M
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pbc00-12104Kit11124

Table des Matières