To Re-Thread The Collar; To Pair The Receiver Collar And The Remote Transmitter - Petsafe ST-70 Manuel D'utilisation Et De Dressage

4. Check the tightness of the Receiver Collar
by inserting one fi nger between the collar and
your dog's neck (3C). The fi t should be snug but
not constricting.
5. Allow your dog to wear the Receiver Collar for
several minutes then recheck the fi t. Check the fi t
again as your dog becomes more comfortable
with the Receiver Collar.
6. Trim the collar as follows: (D). Mark the desired
length of the collar with a pen. Allow for
growth if your dog is young or grows a
thick winter coat. Remove the Receiver
Collar from your dog and cut off excess.
Before placing the Receiver Collar back
onto your dog, seal the edge of the cut
collar by applying a fl ame along the
frayed edge.

To Re-Thread the Collar

Slide Buckle
• The slide buckle prevents the collar from becoming loose around your pet's neck.
• The ridges must be facing up; the collar will slip if it is not properly threaded.
STEP 4
To Pair the Receiver Collar and the
Remote Transmitter
If your Receiver Collar does not beep when the Tone button of the Remote Transmitter is
pressed, or if the Receiver Collar is not responding to the Remote Transmitter, follow these steps:
10
The Receiver Collar should not be worn for more than 12 hours out
of every 24-hour period. Leaving the collar on too long could lead
to skin irritation. Please refer to page 2 for additional information.
Ridges
www.petsafe.net
3C
D