Adjusting The Collar To The Spray Device; Filling The Device - Petsafe KIT11124 Manuel D'utilisation

Contrôle des aboiements por vaporisation
Masquer les pouces Voir aussi pour KIT11124:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
.

Adjusting the collar to the spray device

1. Remove the keeper from the black collar (A). Pass the black collar (B) through the loops of the
spray device (C). Put the keeper back on the collar (D). The curved edge of the keeper should
face inward.
A
2. Feed the free end of the collar into the slot of the buckle that is closest to the PetSafe
from the back to the front (E). Then, thread the free end of the collar through the outside slot,
from the front to the back (F). The free end should now hang on the outside, then thread the
keeper (G). When you have completed this section, the assembled collar looks as shown (H).
E
Take off all other collars your dog may be wearing and place the spray collar
around his neck, making sure the spray valve is directed toward the snout.
Adjust the collar to fit like a regular collar. You should be able to easily pass
two fingers between your dog's neck and the device (I). We suggest that
you check the collar regularly to make sure that it is well adjusted.
Note: If these instructions are not properly followed, the buckle can easily
be pulled off the collar. This could lead to the device being lost or damaged.
Your dog must get used to the device before you actually start using it. We
suggest that you make your dog wear the Spray Bark Control 4 to 5 days
before inserting the battery and filling the device. At the same time, we also
suggest that you remove and put the collar back on your dog frequently.

Filling the device

The Spray Bark Control has a see-through reservoir with a level indicator to help you see when
your reservoir is getting empty (J).
1. Set the device on a flat surface with the fill-up valve (the deepest cavity) turned upwards (K).
Shake the spray can before using it.
2. Hold the can upside down, then insert the aerosol tip in the fill-up valve (L) – press down
firmly for 10 seconds (M). Release pressure and press down for another 10 seconds, then
release.
6
B
F
www.petsafe.net
C
G
D
®
logo,
H
I

Publicité

Table des Matières
loading

Table des Matières