EUROM Heat and Beat Tower Manuel D'utilisation page 26

Remove all package material (including the shock absorbing material around the
bulb) before installating the heater and check the appliance, supply cord and the plug
for signs of damage. Remove also the plastic white protection foil of the base plate.
Install the heater according to the
drawing below with the supplied
screws on the base plate.
Carefully choose the right place to install your heater.
Before placing, check that the minimum safe distances between the surroundings
and the chosen location are respected:
Minimum distance heater – heated object: 1 metre
Minimum distance top* heater – fire-resistant ceiling: 0.25 metres
Minimum distance top* heater – tent tarpaulin, parasol etc.: 0.5 metres
Minimum distance side heater – walls, obstacles, objects: 0.5 metres
If you suspend the device outside, ensure that it is protected from the wind.
Pay attention:
 However you install the Eurom Heat and Beat Tower, always lead the electrical
cable directly away from the heater. It may not become hot!
 For personal protection the installation, to which the Eurom Heat and Beat Tower
is connected, has to be equipped with an earth fall device (max. 30 mAmp). Only
connect the heater to an earthed socket!
Working
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened on the base plate firmly. Mechanical bearing
pressure, oscillating duet o wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V~50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
Remote control operation
The Eurom Heat and Beat Tower has a remote control that works with two batteries:
AAA, 1.5V (not included).
While using, point the remote control to the receiving point of the heater. If there
are obstacles between remote control and the heater, it will not work! The commands
26