Maintenance - Husqvarna 330i Manuel D'utilisation

2. Figure out where the point of maximum tension is.
3. Examine which is the safest procedure to release the
tension.
Note: In some situations the only safe procedure is
to use a winch and not your product.
4. Keep a position where the tree or branch can not hit
you when the tension is released.
5. Make one or more cuts of sufficient depth necessary
to decrease the tension. Cut at or near the point of
maximum tension. Make the tree or branch break at
the point of maximum tension.
Introduction
WARNING: Before you do maintenance,
you must read and understand the safety
chapter.
Maintenance and checks of the
safety devices on the product
To do a check of the front hand guard
Regularly do a check of the front hand guard and the
inertia brake release.
958 - 001 - 16.11.2018
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in.
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.

Maintenance

1. Make sure that the front hand guard is not damaged
and that there are no defects, such as cracks.
WARNING: Do not cut straight through a
tree or branch that is in tension.
WARNING: Be very careful when you
cut a tree that is in tension. There is a
risk that the tree moves quickly before or
after you cut it. Serious injury can occur
if you are in an incorrect position or if
you cut incorrectly.
23