Husqvarna 330i Manuel D'utilisation page 15

oxidizing, which causes the saw chain to
become stiff and that the bar tip sprocket
gets clogged.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To connect the battery to the battery
charger
Note: Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
958 - 001 - 16.11.2018
4. When all LEDs on the battery come on, the battery is
fully charged.
A
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note: Refer to the battery and battery charger manuals
for more information.
To start the product
1. Do a check of the power trigger and power trigger
To do a check of the power trigger
lockout. See
lockout on page 24 .
2. Push the front hand guard forward to engage the
chain brake.
3. Put the battery in the battery holder.
4. Press on the lower part of the battery until you hear
a click sound.
CAUTION: If the battery does not move
into the battery holder easily, it is not
attached correctly into the battery holder.
B C D
15