Husqvarna 330i Manuel D'utilisation page 18

the tree when you cut. In this position you have
better control of the product and the position of the
kickback zone.
• To cut on the push stroke is when you cut with the
top of the guide bar. The saw chain pushes the
product in the direction of the operator.
WARNING: Be careful when you cut on
the push stroke. If the saw chain gets
trapped in the trunk, the product can be
pushed at you. You must prevent this
force or there is a risk that the kickback
zone of the guide bar touches the tree.
This will lead to a kickback.
1. Put the trunk on a saw horse or runners.
18
WARNING: Do not try to cut trunks in a
pile. That increases the risk of kickback
and can result in serious injury or death.
2. Cut the trunks one by one.
3. Remove the cut pieces from the cutting area.
WARNING: The kickback risk increases
if you keep cutting pieces in the cutting
area. It is also a risk that you do not
keep your balance during operation.
To cut a trunk on the ground
WARNING: Follow the steps below to
prevent the saw chain from touching the
ground or an object.
Note: To cut trunks on the ground decreases the risk
that the saw chain gets trapped or that the object breaks.
1. Cut through the trunk on the pull stroke. Do not let
the saw chain touch the ground when you complete
the kerf. Keep full power but be prepared for sudden
accidents.
2. To prevent accidents, cut approximately 2/3 through
the trunk and then stop. Turn the trunk and cut from
the opposite side to complete the task.
958 - 001 - 16.11.2018