Husqvarna 330i Manuel D'utilisation page 13

1. Disengage the chain brake.
2. Loosen the knob and remove the drive sprocket
cover (chain brake) and the transportation ring (A).
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
4. Make sure that the edges of the cutting links are
turned forward on the top edge of the guide bar.
5. Make sure that the edges of the cutting links face
forward on the top edge of the guide bar.
6. Assemble the drive sprocket cover and steer the
chain adjuster pin to the hole in the guide bar.
7. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
8. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
9. Tighten the saw chain. See
on page 28 for instructions.
958 - 001 - 16.11.2018
A
To tighten the saw chain
To assemble the guide bar and saw
chain (535i XP)
WARNING: Always remove the battery
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Loosen the bar nut and remove the drive sprocket
cover and the transportation ring (A).
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
4. Make sure that the edges of the cutting links are
turned forward on the top edge of the guide bar.
5. Make sure that the edges of the cutting links face
forward on the top edge of the guide bar.
6. Assemble the drive sprocket cover and steer the
chain adjuster pin to the hole in the guide bar.
7. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
A
13