VOLTCRAFT VC-1506 Notice D'emploi page 102

• Briefly press the button „Start/Enter". „ON" (or „OFF") starts to blink in the top display line.
• With the buttons „+>" or „
• Briefly press the button „Start/Enter" for saving. „ON" (or „OFF") starts to blink in the bottom display line.
• With the buttons „+>" or „
• Save the setting by pressing the „Start/Enter" button.
• With the „+>" button, you access the next setting (or with the button „
menu with the button „Batt Type/Stop".
• Briefly press the button „Start/Enter". The voltage value then begins to flash.
• With the buttons „+>" or „
• Save the setting with the button „Start/Enter"; the voltage stops blinking.
• With the „+>" button, you access the next setting (or with the button „
menu with the button „Batt Type/Stop".
10
", you can select between „ON" and „OFF".
-
<
", you can select between „ON" and „OFF".
-
<
", you can select the voltage value (10 to 11V).
-
<
With the option „Button Beep", you activate/deactivate the confir-
mation beep at every push of a button.
The option „Buzzer" switches the signal of functions/warning
messages on or off.
" the previous setting). Return to the main
-
<
This function monitors the voltage at the charger input (e.g. for
a 12V accumulator). If the voltage drops below the configured
value, the charging process is stopped.
" the previous setting). Return to the main
-
<