After Use; Grass Catcher; Transportation; Troubleshooting - PrimAster PMLV 1700 Manuel D'utilisation

3. If the cutting device should happen to fail despite the
care taken in manufacturing and testing, repair should
be carried out by an authorized specialist.
4. Do not clean the product while it is running.
5. Ensure that all the fastening elements (screws, nuts,
etc.) are tight at all times so that you can safely work
with the product.
6. Check the product frequently for signs of wear. Re-
place worn or damaged parts.
7. Store your product in a dry place. To ensure a long
service life all screw parts should be cleaned and then
oiled.
8. Clean the product with a brush or cloth. Do not use
any solvents or water to remove dirt.
9. The component that is subject to most wear is the
cutting device. You should therefore check the condi-
tion of the cutting device and its mounting at regular
intervals.
- If the cutting device is worn or blunt it must be re-
placed immediately;
- If the product starts to suffer from excessive vibra-
tions, this means that the cutting device has not
been balanced correctly or has suffered deforma-
tion due to impacts. In this case it must be repaired
or replaced.

12. TROUBLESHOOTING

WARNING! Only perform the steps described in these instructions! All further inspection, maintenance and
repair work must be performed by a qualified specialist! Contact a specialist if the problem cannot be solved
by yourself!
WARNING! If the product does not perform properly, or sound are abnormal, or motor cannot be started, or
stopped as described, or the cutting device does not work properly, or any other irregularity, or malfunction oc-
curs, do not attempt to repair the product by yourself.
Please contact helpline or service center.
Before carrying out any maintenance operations, cut off the electric power supply by disconnecting
the plug from the extension cable.
Fault
Motor does not run
Roller does not rotate
Motor output drops
Poor scarifying perfomance
Noisy running, application vibrates
Fault, which cannot be rectified with the help of this table, may only be attended to be an authorized company
(workshop).
GB | Operating Instructions

After use

1. Switch the product off, disconnect it from the power
2. Check, clean and store the product as described be-
3. Turn the adjusting knob (7) to the „HIGH" position.
4. Loosen the fasteners (4) and (9), with which the han-

Grass catcher

1. Inspect the grass catcher before each use. Do not
2. Clean the grass catcher after operation. Let the grass

Transportation

1. Switch the product off and disconnect it from power
2. Turn the adjusting knob (7) to the „HIGH" position.
3. Attach transportation guards, if applicable.
4. Always transport the product by its handle.
5. Protect the product from any heavy impact or strong
6. Secure the product to prevent it from slipping or fall-
Cause
No voltage
Roller blocked
Toothed belt defective
Working depth too high
Dirty housing
Lawn too long for scarifying
Working depth too high
Worn blades
Balde damaged
GB-12
supply and let it cool down.
low.
dle parts are locked in place. The handle can then
be folded down into a Z-shape to save storage space
(fig. 15).
use it if you find any damage.
catcher dry thoroughly before storing to avoid mildew.
supply before transporting it anywhere.
vibrations which may occur during transportation in
vehicles.
ing over.
Remedy
Check connection line and connec-
tion protection switch
Check roller
Workshop
Selected lower working depth
Clean housing
Lawn too long for scarifying
Select lower working depth
Replace worn blade
Workshop