Setting Up And Aligning; The Scale; Attaching The Length Tape Measure; Operation - Seca 727 Mode D'emploi Et Garantie

5.4 Setting up and aligning the scale

5.5 Attaching the length tape measure

6. OPERATION

The scale is fully assembled on delivery.
Place the scale on a flat, stable surface.
NOTICE!
Incorrect measurement due to force shunts
If the housing of the scale is resting on some-
thing, e. g. a towel, the weight will not be meas-
ured correctly.
– Set up the scale so that it is only in contact
with the floor with the device feet.
The scale is supplied with a length tape measure. To
affix it, proceed as outlined below.
1. Thoroughly clean and disinfect the tray (see
"Hygiene treatment" on page 72).
NOTE
The tray must be clean and dry before you affix
the length tape measure.
2. Peel the protective film off the rear of the length
tape measure.
3. Affix the length tape measure parallel to the top
edge of the tray on the retaining wall, as shown in
the adjacent illustration.
CAUTION!
Damage to persons
Perform a function check as described in the
section entitled "Function check" on page 74
before using the device each time.
English
Operation • 59