Accessories; Correction Of Malfunctions - WAGNER W 590 FLEXIO Mode D'emploi

GB
Pos. Benennung
1 Air ilter cover (right + left)
2 Air ilter set (2 pcs.)
3 Stirring rod
4 Feed hopper (3 pcs.)
Lubricating grease (no ig.)

22. Accessories

The CLICK&PAINT SYSTEM with additional spray attachments and accessories ofers
the right tool for each work.
Further information about the WAGNER range of products for renovating is available
under www.wagner-group.com

23. Correction of Malfunctions

Problem
No coating material
emerges from the
nozzle
Coating material
drips from the
nozzle
Atomisation too
coarse
34
Spare Parts List W 590 (Fig. 25)
Cause
•
Nozzle clogged
•
Feed tube clogged
•
Material volume setting turned
too far to the left (-)
•
Feed tube loose
•
No pressure build-up in container
•
Ventilating bore (Fig. 12, 1)
clogged
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
•
Coating material too thick
•
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
•
Nozzle contaminated
•
Air ilter heavily soiled
•
Too little pressure build-up in
container
•
Amount of air too low
W 590 Flexio
Best. Nr.
2335 172
2367 285
2304 419
2304 028
2315 539
Remedy
➞ Clean
➞ Clean
➞ Turn to the right (+)
➞ Insert
➞ Tighten container
➞ Clean
➞ Tighten
➞ Change
➞ Change
➞ Clean
➞ Dilute
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean
➞ Change
➞ Tighten container
➞ Increase air quantity