WAGNER W 590 FLEXIO Mode D'emploi page 30

GB
2. Electrical Safety
a) The tool plug must it into the socket. The plug may not be modiied in any
form. Do not use adaptor plugs together with protective-earthed tools.
Unmodiied plugs and suitable sockets reduce the risk of an electric shock.
b) Avoid physical contact with earthed surfaces such as pipes, heating
elements, stoves and refrigerators. The risk through electric shock increases if
your body is earthed.
c) Keep the equipment away from rain and moisture. The risk of an electric shock
increases if water penetrates electrical equipment.
d) Do not misuse the mains lead by carrying the tool by the lead, hanging it
from the lead or by pulling on the lead to remove the plug. Keep the lead
away from heat, oil, sharp edges or moving tool parts. Damaged or twisted
leads increase the risk of an electric shock.
e) If you work outdoors with a power tool, only use extension cables suitable
for outdoor use. The use of an extension lead that is suitable for outdoors reduces
the risk of an electric shock.
f) If you cannot avoid using the tool in a damp environment, use a residual
current operated circuit-breaker. Using a residual current operated circuit-breaker
avoids the risk of electric shock.
3. Safety of Persons
a) Be attentive. Pay attention to what you are doing and work sensibly with
a power tool. Do not use the tool if you are tired or under the inluence of
drugs, alcohol or medication. Just a moment of inattentiveness while using the
tool can lead to serious injuries.
b) Wear personal safety equipment and always wear safety goggles Wearing
personal protective equipment, such as dust mask, non-slip safety shoes, safety helm
or ear protection, depending on the type of power tools, reduces the risk of injury.
c) Avoid accidental starting-up. Make sure that the electric tool is switched of
before you connect it to the power supply, pick it up or carry it. Accidents can
occur if you carry the power tool while your inger is on the switch or if you connect
the power tool to the power supply which it is on.
d) Remove setting tools or wrenches before switching on the power tool. A tool
or wrench that is in a rotating tool part can lead to injuries.
22
W 590 Flexio