Electronic Control Setup Instructions - Maytag Commercial MLE22PD Instructions D'installation

Masquer les pouces Voir aussi pour MLE22PD:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ELECTRONIC CONTROL SETUP INSTRUCTIONS

Washer Control
NOTE: After the Washer/Dryer has been installed and plugged
in, the display will show "0 MINUTES" on the Washer and dryer
portions of the display. After the Washer and dryer doors have
been opened and closed, the display will show the price for
each machine. On Washer/Dryers set for free cycles, the display
sections will flash "SELECT CYCLE."
1. PD Models: Insert coins until "SELECT CYCLE" flashes on
the display portion of the Washer or dryer that is to be run.
PN Models: Sent from the factory as Free Vend. If a debit
card reader is installed, then a debit card is required rather
than coins. Generation 1 or 2 debit card systems may be
used; but when the Generation 2 debit system is used, the
controls will automatically be set to Enhanced Debit mode
(J. Ed). In Enhanced Debit mode, the card balance will also
display when a debit card is inserted into the reader.
2. Door must be closed on the desired Washer/Dryer before
cycle selection is made.
3. Press the fabric setting button for the Washer/Dryer cycle
desired. After the cycle is started, the time will display and
count down.
4. If a cycle is interrupted by opening the door or power loss,
"RESELECT CYCLE" will flash in the display. To restart the
Washer/Dryer, close door and reselect desired cycle.
NOTE: When set for free vend operation an ongoing dryer cycle
will cancel if the door is opened.
30
Dryer Control
General Washer/Dryer User Information
SCROLLING "OUT OF ORDER" MESSAGE, FOLLOWED BY
A FAILURE OR DIAGNOSTIC CODE, SHOWING IN DISPLAY
– This condition indicates the Washer/Dryer is inoperative.
Diagnostic codes being displayed on the upper portion of
the display pertain to the dryer section, and diagnostic codes
displayed on the lower portion of the display apply to the
Washer section. Diagnostic codes displayed on both the upper
and lower portions of the display pertain to the control system of
both the Washer and dryer.
"0 MINUTES" SHOWING IN DISPLAY – This indicates the cycle
is complete and the Washer/Dryer cannot be operated. Coins
dropped or debit inputs during this condition will be stored in
escrow but cannot be used until normal operation is restored
by opening and closing the door. If a door switch has failed,
causing "0 MINUTES" to remain in the display after the door is
opened and closed, it must be replaced before normal operation
can be restored.
COLD START (Initial first use) – Washer/Dryer is programmed
at the factory as follows:
Washer
11-minute wash period
1.75 wash price (PD models)
0.00 wash price (PN models)
three rinses (extra rinse not enabled)
Dryer
5 minutes per coin for PD models
45 minutes dry time for PN models
1.50 dry price (fixed cycle with top off –
PD Models)
0.00 dry price (fixed cycle – PN Models)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mle22pnMlg22pdMlg22pn

Table des Matières