Installing Stacked Washer/Dryer; Remove Transport System - Maytag Commercial MLE22PD Instructions D'installation

INSTALLING STACKED WASHER/DRYER

Remove Transport System

NOTE: Slide Washer/Dryer onto cardboard or hardboard before
moving to avoid damaging floor covering.
IMPORTANT: Position the Washer/Dryer so that the rear of
the Washer is within approximately 900 mm (3 ft.) of its final
location.
There are four shipping bolts in the rear panel of the Washer that
support the suspension system during transportation. These
bolts also retain the power cord inside the Washer until the bolts
are removed.
IMPORTANT: Remove the four shipping bolts at the rear of the
Washer before operation.
1. Keep the Washer/Dryer in the upright position while
removing the shipping bolts.
2. Using a 13 mm (1/2") wrench, loosen each of the bolts.
3. Once the bolt is loose, move it to the centre of the hole and
completely pull out the bolt, including the plastic spacer
covering the bolt. Once all four bolts are removed, discard
the bolts and spacers.
18
4. Models with separate Washer power cords: Push the power
cord plug into the opening on the right side of the rear panel
and pull the power cord through the opening on the left side
of the rear panel and close holes with the attached cap. Do
not pull plug end of power cord through the right side hole.
NOTE: To avoid damage to internal Washer parts or the
power cord, if the cord does not pull out of the Washer rear
panel easily,do not force it. Remove the Washer rear panel
and guide the power cord around the obstruction and out
the hole on the left side of the rear panel.
5. Close the bolt holes with the four transport bolt hole plugs.
IMPORTANT: If the Washer/Dryer is to be transported, call
your product distributor or installer. To avoid suspension and
structural damage, your Washer/Dryer must be properly set
up for relocation by a trained professional.