Maytag Commercial MLE22PD Instructions D'installation page 25

Replace the Door Assembly
1. Place the inner door assembly inside the outer door
assembly.
2. Reassemble the inner and outer door assemblies with the
six screws.
Reverse the Strike
1. Use a small flat-blade screwdriver to remove the plug
strip from the dryer door opening. Slide the head of the
screwdriver under the plugs, without scratching the dryer
surface, and lift up the strip.
REVERSING DRYER DOOR SWING (OPTIONAL)
2. Remove the strike using a Phillips screwdriver.
3. Insert strike on the opposite side.
Reinstall the Door
1. Partially insert the third screw from the top; then slide the
hinge onto this screw while hooking the hinge into the front
panel hole. Reattach door to dryer front panel with the
remaining three screws.
2. Check for fingerprints on the glass. Clean if necessary.
3. Close door and check that it latches securely.
25