Stacked Washer/Dryer Maintenance Instructions - Maytag Commercial MLE22PD Instructions D'installation

STACKED WASHER/DRYER MAINTENANCE INSTRUCTIONS

Washer
Cleaning the Door Seal/Bellow
1. Open the Washer door and remove any clothing or items
from the Washer.
2. Inspect inner glass door. If debris is present, wipe it off using
a damp cloth.
3. Inspect the colored seal/bellow between the door opening
and the drum for stained areas. Pull back the seal/bellow to
inspect all areas under the seal/bellow and to check for
foreign objects.
Seal/Bellow
4. If stained areas are found, wipe down these areas of the
seal/bellow:
a) Mix a dilute solution, using 177 mL (3/4 cup) of liquid
chlorine bleach, and 3.8 L (1 gal.) of warm tap water.
b) Wipe the seal/bellow area with the dilute solution, using a
damp cloth.
c) Let stand 5 minutes.
d) Wipe down area thoroughly with a dry cloth and let the
Washer interior air dry with door open.
IMPORTANT:
Wear rubber gloves when cleaning for prolonged periods.
͜
Refer to the bleach manufacturer's instructions for proper
͜
use.
Maintenance Instructions:
This Washer has a special cycle that uses higher water volumes
in combination with liquid chlorine bleach to thoroughly clean
the inside of the Washer.
NOTES:
Read these instructions completely before beginning the
͜
cleaning process.
If necessary, the cleaning cycle may be interrupted by
͜
pressing the Start button twice. However, this will not
immediately stop the cycle. The Washer will continue with
several rinse and drain steps to ensure that all remaining
bleach is rinsed from the Washer.
26
To clean Washer interior:
1. Open the Washer door and remove any clothing or items
from the Washer.
2. Use liquid chlorine bleach:
Open the dispenser drawer and immediately add
160 mL (2/3 cup) of liquid chlorine bleach to the bleach
compartment.
NOTE: Do not add any detergent. Use of more than 160 mL
(2/3 cup) of bleach will cause product damage over time.
3. Close the Washer door and the dispenser drawer.
4. To start the Washer Cleanout cycle, first enter "Service
Mode." Then press and hold the DELICATES button for
2 seconds. Press the EXTRA RINSE button until P-08 is
displayed; then press the START button to start the cycle.
NOTE: The door will lock, the drum will rotate 1/2 turn,
then the door will unlock and lock again, then the Washer
Cleanout Cycle will continue.
The Washer will not fill, but the drum will rotate while
͜
the Washer runs a short sensing cycle. This will take
approximately 3 minutes.
5. The cycle will determine whether clothing or other items are
in the Washer.
a) If no items are detected in the Washer, it will proceed to
Step 6.
b) If any items are detected in the Washer, "F-34" will be
displayed. Then the door will unlock.
Enter the service mode and then press and hold the START
͜
button to cancel the failure code. Then repeat steps 1, 3,
and 4 to start the cycle again.
6. Once the cycle has begun, allow the cycle to complete.
7. After the cycle is complete, leave the door open slightly to
allow for better ventilation and drying of Washer interior.