Earthing Instructions - Maytag Commercial MLE22PD Instructions D'installation

STACKED WASHER/GAS DRYER INSTALLATION REQUIREMENTS
Stacked Washer/Gas Dryer Electrical Requirements
IMPORTANT: Observe all governing codes and ordinances.
You will need an earthed electrical outlet located within 610 mm
(2 feet) of either side of the Washer/Dryer.
This Washer/Dryer is supplied/fitted with an electrical supply
cord and plug. It should be connected to electrical supply
socket at the voltage shown on the rating plate. The minimum
supply fuse capacity should be 10 A. The Washer/Dryer must be
positioned so that the plug is clearly visible and accessible. This
plug also provides the function of an emergency stop control for
the user. If the fitted plug is not used, the electrical connection
must be carried out by a competent electrician in accordance
with local or national codes.
If the supply cord is damaged, it must be replaced with a
specially terminated cord by an authorised service agent or a
similarly competent person in order to avoid a hazard.
Do not use an adapter.
Do not use an extension cord.
NOTE: In accordance with the European EMC Directive
(2014/30/EU), the maximum electricity supply system
impedance to which the gas dryer should be connected is
declared to be 0.054 Ohm + j0.034 Ohm.
NOTE: Electrical safety standards: The manufacturer has
chosen compliance with IEC/EN 60335 standards as the most
appropriate for this product.
If codes permit and an additional earth bond wire is used, it is
recommended that a qualified electrician determine that the
earth bond path is adequate.

EARTHING INSTRUCTIONS

For an earthed cord-connected dryer:
͜
This dryer must be earthed. In the event of a malfunction or
breakdown, earthing will reduce the risk of electric shock by
providing a path of least resistance for electric current. This
dryer is equipped with a cord having an equipment-earthing
conductor and an earthing plug. The plug must be plugged
into an appropriate outlet that is properly installed and
earthed in accordance with all local codes and ordinances.
WARNING : Improper connection of the equipment-earthing
conductor can result in a risk of electric shock. Check with a
qualified electrician or service representative or personnel if
you are in doubt as to whether the dryer is properly earthed.
Do not modify the plug provided with the dryer; if it will not
fit the outlet, have a proper outlet installed by a qualified
electrician.
SAVE THESE INSTRUCTIONS
Using the universal cord included with this dryer:
The gas dryer is equipped with a universal cord with
interchangeable plugs.
1. To use the universal cord, select the plug end that fits your
electrical outlet, and plug it into the adapter on the supply
cord.
2. Secure the plug end in place on the cord by aligning the
two cover halves over the cord adapter and clipping them
together.
11