B-1. Parallel Interface Type - Star TSP Série Mode D'emploi

B-1. Parallel Interface Type

ON
OFF
No. 1 2 3 4 5 6 7 8
DIP-SW1
Switch 1-1
OFF
All factory settings for dipswitch 1 on the auto cutter model are set at [ON].
Switch 1-3 on the tear bar model is set at [OFF], and the others are set at [ON].
The functions of switches 1-2 through 1-8 will change according to the command
emulation that has been set using switch 1-1.
(1) Star mode
Switch
1-1 Command emulation
1-2 Should not be changed (Should be set to on)
1-3 Auto cutter
1-4 Sensor adjustment
1-5 Pin #31 (INIT) reset signal
1-6 Handshaking conditions
(conditions for BUSY)
1-7 Automatic status back function
1-8 Should not be changed (Should be set to on)
(2) ESC/POS mode
Switch
1-1 Command emulation
1-2 Graphic adjustment
1-3 Auto cutter
1-4 Sensor adjustment
1-5 Pin #31 (INIT) reset signal
1-6 Handshaking conditions
(conditions for BUSY)
1-7 Automatic status back function
1-8 Should not be changed (Should be set to on)
DIP-SW 1
ON
Function
Function
ON
OFF
No. 1 2 3 4
DIP-SW2
Command emulation
Star Mode
ESC/POS Mode
ON
Always ON
Valid
Invalid
Valid
Offline or receive
buffer full
Invalid
ON
Always OFF
203 DPI
Valid
Invalid
Valid
Offline or receive
buffer full
Invalid
– 99 –
OFF
Invalid
Valid
Invalid
Receive buffer full
Valid
OFF
180 DPI
Invalid
Valid
Invalid
Receive buffer full
Valid