A-2. Auto Cutter Specifications; A-3. Interface; A-4. Electrical Characteristics; A-5. Option - Star TSP Série Mode D'emploi

A-2. Auto Cutter Specifications

(1) Cutting frequency
(2) Thickness of paper

A-3. Interface

RS232C serial interface or Two-way parallel interface (IEEE1284)

A-4. Electrical Characteristics

(1) Input Voltage
(2) Current Consumption Operating: Approx. 1.3 A (at ASCII printing)
(3) Power Connector
Pin No. Function
1 DC24V
2 Signal GND
3 N.C.
Shell Frame ground
Important!
• When using a printer power supply other than the optional AC adaptor
(PS60-24A), be sure that the following cautions are observed.
• Use a power supply of DC 24 V ±10% and more than 2.0 A (5.0 A Load
10 sec. Min) with SELV output approved by IEC60950.
• Be careful about installing the printer in an area where there is noise.
Take the appropriate measures to protect against electrostatic AC line
noise, etc.

A-5. Option

(1) Wall Mount Set (WB-T600)
(2) Vertical Stand Set (VS-T600)
(3) USB Interface Board Unit (IFBD-HU04)
(4) Parallel Interface Board Unit (IFBD-HC04)
(5) 25 Pin RS-232C Interface Board Unit (IFBD-HD04)
(6) 9 Pin RS-232C Interface Board Unit (IFBD-HN04)
Max. 20 cuts per minute
65~85 µm
DC 24V±10%
Peak: Approx. 8 A (at print duty 100%,
for 10 seconds or less)
Stand-by: Approx. 0.05 A
<Viewed from Connector Surface>
– 96 –
3
1
2