S+S Regeltechnik THERMASGARD Série Notice D'instruction page 22

G
EtherCAT P | Configuration (general)
Description of MODULE DISPL AY
The central control element is the LCD Programming ( 0x8000 ) bit, which controls the free description of the display. If this bit
is set to ON, the RxPDOs (equivalent to objects 0x7000...0x7004) can be used to describe the display individually and to display
proprietary measured values using units or text. The backlight was also incorporated into the process data, for example, to
indicate fault messages by means of flashing backlighting. In addition, special graphics (icons) can be displayed to visualise
operating statuses.
If LCD Programming is deactivated to OFF, the measured values of the existing sensors are displayed with a unit.
For multi-variable sensors, the LCD Cycle Time ( 0x8001 ) is used to define a cycle time in the range from 3 to 180 seconds for
the measured value display. The contrast is set using LCD Contrast ( 0x8002) in the range ±10.
Dot A Dot B
Graphics ( ICON )
ICON 1 ICON 2
Maintenance Error
MODULE BAR GRAPH ( PDO )
Object DataType
0x16n0
0x16n1
0x16n2
Continued with description on next page!
Dot DP1 Dot C Dot DP2
ICON 3
Warning
Name
Bargraph Color Line
Bargraph Value
Bargraph Warning Level
Warning Minimum
Warning Maximum
Bargraph Error Level
Error Minimum
Error Maximum
Dot D Dot E
Upper Line
Lower Line
ICON 4 ICON 5
Setup Info
Description
22
PDO
RxPDO
RxPDO
RxPDO