LGB Frank S Instructions De Service page 8

Smoke Generator
This model is equipped with a
smoke generator. A small supply
of LGB Smoke and Cleaning
Fluid is included with this model.
For best operation, fill the genera-
tor halfway with fluid. If the gener-
ator is overfilled, it will not convert
the fluid into smoke.
Attention! Only use LGB Smoke
and Cleaning Fluid (50010).
Other fluids may damage your
locomotive.
Attention! Never touch the heat-
ing element in the center of the
smoke generator. It is hot and
fragile.
Hint: The smoke generator can
be run "dry" without smoke fluid.
Power Supply
Attention! For safety and reliabil-
ity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies will void your warranty.
Use this model with LGB power
supplies with an output of more
than 1 amp. For more information
on LGB power supplies for indoor,
outdoor and multi-train operation,
see the LGB catalog.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level - Beginner
Level - Intermediate
Level - Advanced
Attention! Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see Authorized Ser-
vice).
Hint: Additional expert instruc-
8
tions for many LGB products are
available at www.lgb.com.
Lubrication
The axle bearings and the side
rod ends should be lubricated
occasionally with a small amount
of LGB Maintenance Oil (50019).
Cleaning
This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water. Do not
immerse this model.
Replacing the light bulbs
Front lanterns and upper rear
lantern: Pull the lantern housing
away from the model. Pull the
plug-in bulb out of the socket.
Plug in a new bulb. Reassemble.
Lower rear lanterns: Remove
the ring around the lantern lens.
Remove the lens. Pull the plug-in
bulb out of the socket. Plug a new
bulb into the socket. Reassemble.
Cab light:
remove and replace the bulb.
Replacing the smoke
generator
- Pull the safety cover out of the
smoke stack (Fig. 4).
- Use pliers or tweezers to pull the
old smoke generator out of the
stack.
- Cut the wires to the old genera-
tor and attach them to the
replacement generator (Fig. 5).
- Insulate the connections and
push the replacement generator
into the stack (Fig. 6).
- Reassemble.
Replacing the traction tire
- Remove the rod guards located
between the first and second
axles.
- Remove the hex head screws
joining the drive rods to the con-
necting rods on the third axle.
- Counting from the front, remove
the second and fifth screws on
the bottom of the gearbox.
- Remove the gearbox from the
chassis. Disconnect the wiring
cable.
- Use a small, straight-blade
screwdriver to pry the old trac-
tion tire out of the wheel groove.
- Use a small, straight-blade
screwdriver to gently pry the
Using tweezers,