Sending Measurement Results To Wireless Receivers; Calculating And Printing Out Bmi Automatically; Automatic Switching Of Weighing Range - Seca 685 Mode D'emploi Et Garantie

Sending measurement
results to wireless
receivers
Calculating and printing
out BMI automatically
Automatic switching of
weighing range
If the scale is integrated in a
work, you can send the measurement results to
devices ready to receive them (e.g. wireless printer, PC
with USB wireless adapter) at the touch of a button.
►
Press the Enter key (send/print).
– Press key briefly: send measurement results
to all devices ready to receive them
– Press and hold key: print out measurement
result on wireless printer
If you use this scale together with a wireless printer and
a length measuring rod from the
system, you can have BMI calculated and printed out
automatically.
NOTE
The prerequisite for this function is that the
devices are registered together in one wireless
group (see "The seca 360° wireless network"
on page 93).
1. Perform the weighing operation.
2. Briefly press the Enter key (send/print) of the
scale.
The measured value is sent to the wireless printer
but not printed.
3. Perform the height measurement.
4. Press and hold the Enter key (send/print) of the
length measuring rod.
The measured value is sent to the wireless printer.
BMI is calculated.
Height, weight and BMI are printed out.
The scale has two weighing ranges. In weighing range
1 ( ), capacity is reduced, but the increments in the
weight display are finer. In weighing range 2 (
can use the maximum capacity of the scale.
After the scale is switched on, weighing range 1 is
active. If a particular weight is exceeded, the scale
automatically switches to weighing range 2.
To switch back to weighing range 1, proceed as
follows.
►
Completely remove the load from the scale.
Weighing range 1 is active again.
English
seca 360° wireless
seca 360° wireless
Operation • 87
net-
), you