Publicité
Les langues disponibles
Les langues disponibles
Dear Customer,
Thank you for purchasing this Hendi appliance. Please read this manual carefully before connecting the
appliance in order to prevent damage due to incorrect use. Read the safety regulations in particular very
carefully.
Important Safety Instructions
• This French fries cutter is only intended for cut-
ting potatos to make French fries in commercial
use such as in the food industry and shops. (e.g.
catering, restaurant, bar, etc.).
• Use the cutter only as described in this manual.
DO NOT use this cutter for cutting other food.
• This cutter should be operated and installed by
specialized trained personnel in the kitchen of
the food industry such as catering, restaurant,
bar, etc.
• Check for damaged parts. Before using the
French fries cutter, check that all parts are in-
cluded in the package, and that any moving
parts are operating properly for performing the
intended functions. Check for alignment of mov-
ing parts, binding of moving parts, and any other
conditions that may affect the operation.
• In case of incomplete delivery or damages, con-
tact the supplier and do not use the appliance
(See ==> Warranty)
French fries cutter parts
No.
Description
1
Feed Frame Assembly
2
Handle
3
Connecting Plate Assembly
4
Slide Bar Assembly
5
Rubber Foot Assembly
6
Long Pin & C-clip
7
Slide Bar Cover Bushing
8
Short Pin & C-clip
• Do not place the cutter on a heating object (gas-
oline, electric, charcoal cooker, etc.)
• Keep the cutter away from any hot surfaces and
open flames. Always operate the cutter on a level,
stable, clean, heat-resistant and dry surface.
• Read all instructions on how to assemble this
French fries cutter, before attempting to use or
clean.
• Be sure the c-clips are securely fastened to the
long and short pins and cutting plate is secure on
the end of the French fries cutter before making
fries.
• Beware! Keep fingers and loose clothing away
from moving parts! Injury may result!
• Keep children away. Never leave the french fries
cutter.
• Clean the cutter before and after each use. (See
==> Cleaning Instructions)
Optional cutting plates - 1/4" and 1/2" are available.
EN
NL
3
Publicité
