Installation And Commissioning - Kerbl 141461 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
2.2 Safe working
CAUTION!
Hot surfaces
CAUTION!
Defective connection cable
Risk of burns, electrical shock, fires and short circuits.
• Do not allow electrical supply cables to come into contact with hot surfaces, heat, oil or sharp edges.
• Do not pull on the electrical supply cable to unplug or transport the device.
• Never operate the device without supervision.
Risk of physical injury and material damage if used incorrectly!
• Ensure that the device is only used by people who have the professional skills required to do so.
• Ensure that the voltage specified on the type plate matches the voltage of your power source.
• The device may only be connected to mains sockets which are isolated separately via a circuit breaker (FI).
• Before each use, check that the device and the power cable in particular are in good condition. Do not operate
the device if a component is defective.
• If the power cable of this device is damaged, it must be replaced by the manufacturer or qualified electrician to avoid danger.
• Never operate the device without supervision.
• Always keep the device in a safe, dry place out of the reach of children.
• Never remove the device type plate or film on the control unit.
• National and international safety, health and occupational safety regulations must be observed and complied with.
• When the device is switched on, the liquid to be heated and stirred must not be touched.
• Disconnect the device from the power supply before cleaning, relocating or servicing it or leaving the room.
• Only use the device in closed spaces.
• Repairs to the device may only be carried out in consultation with the manufacturer and by a qualified electrician.
• Do not reach into rotating parts.
CAUTION!
Failure to observe individual points in the operating instructions can lead to personal injury and property damage,
for which no liability is accepted by the manufacturer.
2.3 Correct use
The machinery is designed to evenly stir milk powder into water. Furthermore, high viscosity fluid can be kept in motion in the MilkPot50 (item
no. 141450) during the heating process, in order to ensure the temperature rises uniformly. The stirrer is not designed for continual operation.
The cover with stirrer is exclusively intended for use in conjunction with a MilkPot50 (item no. 141450).
Any other use, especially the warming of food, is deemed incorrect. In the event of incorrect use or modifications to the device,
the manufacturer's warranty and liabilities shall be deemed invalid.

3. Installation and commissioning

3.1 Scope of delivery
The cover with stirrer motor is exclusively intended for use in conjunction with a MilkPot50 (item no. 141450) milk warmer.
All safety appraisals and operating instructions are based on the combination of the cover with the MilkPot50 milk warmer.
Delivery includes:
• pre-assembled cover with motor and shaft mount
• stirring shaft
• stirrer blades
• second cover half (container cover)
• all screws and fasteners required for installation and operation
• operating instructions
3.2 Checks before commissioning
Before commissioning, the device must always be checked for completeness, visible defects or sources of danger.
The following checking measures should be carried out:
• Check the machine for loose or hanging parts or damage sustained during transport.
• Check the cable insulation.
• Check that all safety devices are present and are in perfect working order.
• Check whether there are any sources of danger near the machine that could impair the problem-free and safe operation of the machine
(water hoses, influence of weather, hanging cables or ropes, etc.).
18

Publicité

Table des Matières
loading

Table des Matières