Maintenance And Repair - Kerbl 1418 Mode D'emploi

3.2.3. Set the desired temperature with the thermostat. ( 0 ) corresponds to the minimum temperature (
ponds to a temperature of approximately 40°C and (
red control lamp lights up.
3.2.4. ATTENTION: Only use your milk heater under permanent supervision.
3.2.5. Pay attention that the level of liquid does not drop below the minimum depth when heating up over a longer
period of time. Under no circumstances cover the milk heater nor the container.
3.2.6. When the red control lamp goes out the desired temperature has been reached. Turn the thermostat to 'minimum
temperature' and pull the plug out of the socket. Leave the milk heater for about another minute in the liquid
before you remove it.
3.2.7. The heating element remains hot even after the plug has been pulled out and should therefore not be touched.
Must not be placed on surfaces that burn easily (e.g. straw)!
3.2.8. The calf's milk heater must be cleaned after every use.
The heater can be cleaned using a soft sponge cloth (do not use
scrubbing brushes, wire brushes, wire wool or other abrasive cleaning
tools) and lukewarm, soapy water. The calf's milk heater should be
placed in cold or warm water immediately after use. This makes the
calf's milk heater easier to clean and protects the PTFE coating. To
clean the handle and the stand pipe, use a soft, damp cloth that
must be completely free of solvents
(acetone, petrol, alcohol or similar).

4. Maintenance and repair

The milk heater is maintenance-free. In case of a malfunction the unit has to be stopped immediately. In case the milk
heater has to be repaired, consult a qualified electrician or send the unit back to the manufacturer. Even a defective
connecting cord must only be replaced by the manufacturer or a qualified electrician.
5. Technical data (1418, 1420)
Output: 2300 W
Power supply: 230 V
Safety classification: IPX 7
Weight: 4.6 kg
CE-/UKCA conformity declaration
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the
fundamental requirements and other relevant stipulations and regulations. The CE-/UKCA mark confirms compliance
with the Directives of the European Union or the releant UK legislation.
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please consult the valid national regulations.
The device must not be disposed of in household waste. In accordance with the stipulations of the EU Directive on the Disposal
of Electrical and Electronic Devices, the device can be disposed of free of charge at the local waste collection or recycling centre.
Alternatively, it can be returned to retailers who offer a collection service. The proper disposal helps to ensure environmental
protection and prevents any adverse effects on human health and the environment.
) to a temperature of about 80°C. While heating up the
7
) corres-