Setting The Isolating Valve And Flushing Water Volume; Range; Changing The Battery; D'acqua Di Risciacquo - Franke AQUA-PROTRONIC AQRE430 Notice De Montage Et De Mise En Service

10.9 Remove your hand from the sensor range after the required flash sequence
(min. 60 cm). Afterwards, the fitting flushes with the set flush volume. The flash
sequence of the corresponding flush volume occurs again after flushing.
10.10 Low flush volume.
10.11 High flush volume.
Flush volume OK:
10.12 Wait 20 seconds outside of the sensor range (the fitting switches automatically to the
normal operating mode).
10.13 Mount the cover.
Flush volume NOK:
10.14 Keep your hand 5 – 10 cm in front of the sensor. The LED flashes.
2 flashes, pause, 3 flashes, pause, 4 flashes, etc.

11. Setting the isolating valve and flushing water volume

View from above
a: fully opened
b: closed

12. Range

12.1 The range can be adjusted using the optional remote control (order
no. 2000101087).

13. Changing the battery

13.1 Loosen the cover using a hexagon socket key.
13.2 Remove the cover.
Caution!
Push the cover on the casing when reassembling so that the rib (S) locks into the
recess (A). Screw on the cover.
13.3 Lift out the battery with a screwdriver (siehe
13.4 Insert a new battery and connect with the contacts in the battery tray.
6
Kapitel 14.6).