Publicité
Les langues disponibles
Les langues disponibles
Only applicable to the thermostat version
When in operation, the display shows the room temperature
If you press the + or - key, the temperature setting will flash 5x on the display.
You can adjust the temperature setting by pressing the + or - key while it is flashing.
With each key press, the temperature will be increased (+) or decreased (-) by one
degree.
The device will retain the temperature setting by switching itself on and off
automatically.
Safety feature
In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in enough
fresh air. As mentioned above, this is generally caused by (partially) covering the heater,
or installing the heater too close to a wall or something similar. In case of overheating,
switch off the heater and unplug. Give the heater time to cool down, remove the source
of the overheating and use as normal. If the problem persists or if you have not been
able to trace the source of the overheating, turn the heater off immediately and unplug.
Contact a servicing point to have the heater repaired.
Cleaning and Maintenance
Keep the heater clean. Switch off the heater, remove the plug from the socket and allow
the heater to cool down before cleaning or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical
solutions!
You can keep the back of the heater free of dust with a feather duster. For thorough
cleaning of the back, you can unscrew the heater from the wall.
If you want to clean away the E-convect at the end of the season, you can simply
unscrew it and store it, if possible in the original packaging, upright in a cool. Dry
and dust-free place.
CE-statement
Euromac bv, Genemuiden-NL hereby declares that the EUROM electrical convector
heater, type E-CONVECT & E-CONVECT with thermostat, complies with the LVD
guideline 2006/95/EG and the EMC guideline 2004/108/EC and meets the following
standards:
EN 60335-1 :2012
EN 60335-2-30 :2009+A11 :2012
EN 62233 :2008
Genemuiden, 26-06-2014
W.J. Bakker, alg.dir.
EN 55014 :2006+A1 :2009+A2 :2011
EN 55014-2 :1997+A1 :2001+A2 :2008
EN 61000-3-2 :2006+A1 :2009+A2 :2009
EN 61000-3-3 :2013
18
Publicité
