EUROM E-CONVECT Manuel D'utilisation page 14

Technical data
Type
Supply voltage
Insulation class
Maximum capacity
Suitable for
Thermostat
Dimensions
Weight
General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. Do not use the heater until it is been fully installed in accordance with the instructions
under the heading 'Description, Composition and Installation'.
4. This heater is strictly intended for normal domestic use. Only use it for the additional
heating of your home.
5. This heater in not suitable for use in wet or damp spaces such as bathrooms and
laundry rooms. Do not place the heater in the vicinity of taps, bathtub, shower, pool,
fountains or other sources of moisture. Make sure it cannot fall into water and prevent
water from getting into the heater itself. If, at any time, the heater does fall into water,
unplug it immediately! Do not use a heater that has a damp interior but have it
repaired. Never immerse the heater, cord or plug in water and never touch it with wet
hands.
6. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. The electrical installation needs to be secured with a
ground-fault circuit interrupter (max. 30 mAmp). The electrical socket that you are
using must be to hand at all times in order to be able to remove the plug from the
socket in the event of an emergency
7. Fully extend the cord before plugging in the heater. Make sure it does not come into
contact with any part of the heater and prevent it from heating up any other way. Do
not run the cord underneath carpeting; do not cover it with mats, carpet strips or
similar and make sure it is not placed in any passageways. Make sure the cord
cannot be stepped on and that no furniture is placed on top of it. Do not lead the
cord around sharp corners and do not roll it up too tightly after use!
8. If possible, do not use an extension cord, as this poses the risk of overheating and
fire. If the use of an extension cord is unavoidable, then make sure it is an
undamaged, approved extension cord with a minimum diameter of 3 x 1.5 mm² and a
minimum permissible power of 500 Watt. To prevent overheating, always fully extend
the cord!
9. During use the plug can feel a little warm, that's normal. Is it really warm, then there
is probably something wrong with the socket. Contact your electrician.
10. To prevent the circuit being overloaded and fuses blowing, make sure no other
appliances are connected to the same socket or wired to the same electrical circuit
as the heater.
English
EUROM E-CONVECT
220-240Volt / 50060Hz
II, double insulated
425 Watt
9 tot 16 m²
-
3,3 (24,8) x 60 x 60 (63) cm.
5,3 kg.
14
EUROM E-CONVECT
with thermostat
220-240Volt / 50060Hz
II, double insulated
425 Watt
9 tot 16 m²
+
3,3 (24,8) x 60 x 60 (63) cm.
5,4 kg.